Hughes Network AN8-074P, Installation Manual

Page: 33 / 62

Chapter 3 • Installing the antenna and radio assembly
1037749-0001 Revision B
19
3. Insert the ¼-inch Phillips head screw through the hole near
the bottom of the reflector, as shown in the figure, and into
the corresponding hole in the reflector bracket arm.
4. Using a Phillips head screwdriver, tighten the ¼-inch screw.
5. From the back of the reflector bracket, secure the four bolts
with four ½-inch hex flange nuts and tighten.
Installing the
feed support arm
To install the feed support arm:
1. Insert the feed support arm into the bottom section of the
reflector bracket, as shown in Figure 13.
2. Insert two 1/4-inch
×
1¾-inch bolts with 7/16-inch hex
heads) down through the tailpiece into the feed support arm.
Figure 12: Attaching the antenna reflector
Note: Ensure that the carriage bolts are firmly seated before
tightening the nuts.