1035930-0001 Revision 2
6-7
Attaching the radio assembly
1.
Check the polarization-setting dial on the rear of the RA6-TG transceiver. See Figure 14.
Make sure that it is set to 0°. If not, set it to 0° now. Reference documents provided with
transceiver for instructions for this procedure.
2.
Place the O-ring into the O-ring groove in the mounting flange of the feed horn assembly. See
Figure 13.
3.
Attach the feed horn assembly to the RA6-TG transceiver using the (6) #6-32 x ½-inch
screws and lock washers.
4.
Tighten securely.
5.
Place the feed horn/RA6-TG transceiver assembly onto the end of the feed support. See
Figure 14.
6.
Align the mounting holes in the transceiver bracket with the holes in the feed support. Secure
with the hardware supplied with the transceiver.
7.
Tighten securely.
O-ring
Feed Horn
Assembly
#6-32 x.50-inch
hardware (6 places)
RA6-TG
Feed Support
Hardware Supplied
with Transceiver
FIGURE 14
FIGURE 13
Transceiver Scale
location, transceiver
polarization should
be set to 0° at time
of installation.
Summary of Contents for DIRECWAY
Page 27: ...1035930 0001 Revision 2 8 4 ...
