ConTour Series 1.0
1.3 MS/1, MS/2, MS/3 Mounting Set for the
CT 108
A three-piece mounting set is available for the
CT 108, enabling the speaker to be placed on a
pole or flown from a truss.
MS/1:
An L-shaped mounting bracket, the MS/1 can be
attached either to the left or right side panel. To
do this, remove the countersunk M8 screws and
use them to affix the MS/1’s mounting plate.
Loosen the knob screws to adjust the tilt angle.
MS/2:
The pole mount adapter for the MS/1; two
bushings that accept MS/2 are located on the
bottom of the MS/1.
MS/3:
The MS/3 TV stud for mounting cabinets on
poles; an 11-mm bushing that accepts the MS/3
TV stud is located on the bottom of the MS/1.
An M8 bushing that accepts an EB 8 eyebolt is
located on the rear panel of the CT 108. Secure
the flown speaker with an arrest wire to prevent it
from falling!
Figure 27 a, b: Attaching the MS/1 yoke to the CT 108
Figure 28: MS/1 mounting yoke CT 108
Figure 29: MS/2 pole mount
Figure 30: MS/3 TV stud
Figure 27 a, b: Attaching the MS/1 yoke to the
CT 108
Figure 29: MS/2 pole mount
Figure 30: MS/3 TV stud
Figure 28: MS/1 mounting yoke CT 108
