21. MONO FX
LOOP
Serial signal path for external effects processors. Connect the
ATTAX’S LOOP
RETURN
to the device’s
OUTPUT
jack. The output signal’s dry/wet mix is regulated
at the processor.
22.
STEREO FX LOOP
The parallel
STEREO EFFECTS LOOP’s dry/wet mix
is regulated via the
FX MIX pot
(14). The effects signal can be activated via the STAGEBOARD or MIDI messages.
Connect the
ATTAX's LOOP SEND
jack to the
device’s INPUT,
and the
ATTAX's
LOOP LEFT/RIGHT RETURN
jacks to the device’s
LEFT/RIGHT OUTPUT
jacks.
Use the
ATTAX STEREO LOOP’S RIGHT RETURN
jack for mono signal processors.
The LOOP sends a mono signal if only the
RIGHT RETURN
jack is connected.
TIP 1: You
can connect other instruments/sound generation equipment to the
ATTAX
via the
STEREO LOOP’S RETURN
jacks instead of a signal processor/effects device.
A second guitar, keyboard, drum machine, tape player, etc. can be used for rehearsals
/ practice sessions.
Adding a
STEREO SIGNAL
(tape deck, keyboard, etc.):
l
Connect the device’s LEFT /RIGHT OUTPUTS to the ATTAX STEREO LOOP’S
LEFT / RIGHT INPUTS.
l
Step on the STAGEBOARD’S FX footswitch (the loop is activated).
l
Regulate the device’s volume via the
FX MIX pot
located on the front panel (to
the left towards DRY =
volume down,
to the right towards WET = volume
up).
TIP 2: You
can also use the loop to activate an additional MASTER VOLUME,
provided you do not connect a signal processor.
Activating the additional MASTER VOLUME
l
Step on the STAGEBOARD’S FX footswitch (the LED illuminates).
l
Dial in a separate MASTER VOLUME setting for the ATTAX via the FX MIX pot (to
the left towards
DRY = volume up,
to the right towards
WET = volume down).
l
You
can switch back and forth between the two MASTER VOLUMES via the
FX footswitch.
Upon MIDI option installation, you can also call MASTER VOLUME changes via MIDI
messages.
23. LINE OUT ( LEFT / RIGHT
)
The two LINE OUT jacks (Left/Right) feed the preamp’s signal to a power amp(s). Use
a single
LINE OUT
jack to drive a mono power amp and speaker cabinet.
page 7
