Huger PM 138 H, User Manual, Page: 7 / 12

4. Press [MODE SET].
hour digits will flash.
5. Press [ ADV] to advance the numbers until
the
hour digit is displayed. Holding
down the button will
9.
increase the rapidly.
Press [MODE SET], the minute digits will flash.
Again, press
ADV] to advance
appropriate minute digit is displayed.
Press [MODE SET], the “seconds” will flash
Again, press ADV] to reset the
When the “seconds” correspond to the correct ti
[MODE SET] to confirm and exit.
numbers until the
‘seconds” to zero.
me and then press
ABOUT THE TIMER
The timer can count up from zero or count down from a pre-set time.
Starting from zero the timer can count to a maximum time of 29-hours,
minutes, and 59-seconds 59”). The unit will also count down from
29-hours, 59-minutes, and 59-seconds to zero. In count-down timer mode,
once the unit reaches zero, if not stopped, the unit will continue and start
counting upwards.
To indicate that the unit is in count-up timer mode an up arrow will
display. Respectively, the count-down mode display is indicated by a down
arrow.
To
USC
count-up timer:
1. If the clock is displayed, press [MODE SET] to enter the count-up
down timer mode [FIG. G]. From pulse mode, press [PULSE@] to
exit pulse mode followed by [MODE SET] to toggle between clock
and count-up down timer modes.
2. If the count-up timer display does not show zero hours, and
seconds, Press and hold [RESET] for 2 seconds to reset the count-up
timer to zero.
3. Press [START STOP] to start the timer.
4. Press [START STOP] again to stop and pause the timer.
5. Press and hold [RESET] for 2 seconds to reset the timer to zero.
To use the count-down timer:
1. If the clock is displayed, press [MODE SET] to enter the count-up
down timer mode [FIG. HJ. From pulse mode, press [PULSE
l
] to
exit pulse mode followed by [MODE SET] to toggle between clock
and count-up down timer modes.
2. To set the count-down timer, press and hold [MODE SET] for 2
seconds, the hour digits will flash.