Hudson 63 1936, Mechanical Procedure Manual

Page: 159 / 333

SECTION 11
Page 20
HUDSON-TERRAPLANE
38. Feed wires through hole in mounting flange of housing
and replace cap (8) and washer (9).
SELECTOR SWITCH-1935
NOTE: Operations Nos. 39 through 49 can be performed with-
out removing the selector assembly from the car or after the
assembly has been removed.
Selector Lever, Shaft and H Plate
39. Remove two screws (85) (Figure 1122) from H plate cap
(84) and remove cap.
40. Turn selector lever 3/4 turn clockwise and withdraw lever
and shaft.
41. Withdraw washer retainer (14), washer (13), springs (12)
and lever (11) from shaft (10).
42. To reassemble, reverse operations 38 through 41.
Selector Cutout Switch
43. Remove 2 screws from cutout switch (86).
44. Lift switch out of housing and unsolder red wires from
switch terminals.
45. Reassemble by reversing operations 43 and 44.
Selector Switch Base and Rotor
46. Remove four screws (83) from column bracket cap (82).
47. Remove cutout switch (86). See operations 43 and 44.
48. Pry out switch base lock ring (17) and withdraw base
(5), rotor (18 spring (19). (See Figure 1123.)
49. To reinstall, reverse operations 46 through 48.
Selector Switch Assembly-Remove
50. Remove cap from jack (6) by lifting until lock lug is out
of groove in jack base and turn cap Y1 turn.
51. Separate male and female halves of jack and unsolder
wires.
52. Remove piece of loom from wires at bottom of jacket
tube.
53. Remove four screws (83) from column bracket cap (82).
54. Draw wires out of jacket tube.
Selector Switch Assembly-Install
55. Straighten the eight wires of the selector harness and lay
them side by side so that they do not cross one another. Feed
all eight wires into the steering column tube side by side. (See
Figure 1120.)
56. Put the selector in position on the steering column tube
and secure with cap (82) and four screws (83).
57. Put piece of loom over lower end of wires.
58. Solder wires to terminals of connector (6). See Figure
1119 for wire color codes. Be sure wires are attached to
correct terminals as indicated by code letters on lower face of
connector.
Figure 1123
Figure 11234