Hudson 1953 Super Jet, Mechanical Procedure Manual

Page: 65 / 156

ELECTRICAL SYSTEM 60
SECTION 6
ELECTRICAL SYSTEM
SPECIFICATIONS
GENERATOR
Make and Model
Type and Volts
Control
Controlled Output
Poles
Brushes
Brush Spring Tension
Bearings:
Commutator End
Drive End
Armature Shaft End Play
Ground Polarity
Field Coil Draw
Motorizing Draw
Output Test:
Cold
Hot
Auto-Lite GGW-4802A
Shunt - 6 Volt
Vibrating type current - Voltage Regulator
45 Amperes
2
2
35 to 53 ounces with new brushes
Bronze
Ball
003" to .010"
Positive
1.4 to 1.5 amperes at 5.0 volts. Measure from
armature to field terminals.
4.1 t o 4.6 amperes at 5.0 volts. Have field
grounded to frame and measure from
armature terminal to a ground on the frame.
6 4 volts, 0 amperes at 870 to 970 RPM
8.0 volts, 45.0 amperes at 1925 to 2125 RPM
6 4 volts, 0 amperes at 950 to 1050 RPM
8.0 volts, 45.0 amperes at 2350 to 2550 RPM
GENERATOR REGULATOR
Make and Model
Volts
Ground Polarity
Resistors:
R1
R2
Cutout Relay
Armature Air Gap
Contact Point Gap
Contacts Close
Contacts Open
Current Regulator
Armature Air Gap
Operating Amperage
Armature Spring
Auto-Lite VBE-6104A
6
Positive
34.5 to 42.0 OHMS (Marked 38)
6 5 to 8.0 OHMS (Marked 7)
Resistance of voltage winding 29.8 to 33.0 ohms
031" to .034" contacts should be open and the
armature against the upper stop. Measure the
gap with the gauge as near to the hinge as pos-
sible.
015" minimum
6.3 to 6.8 Volts
4.1 to 4.8 Volts after a charge of 15 amperes
.048" t o .052" contacts should be closed with
the high limit gauge in place and open with the
low limit gauge in place on the contact side and
next to the brass armature stop pin.
43-47 (at 70°)
14-1/2 turns