Page
3
of
5
Air Feed
The air feed must be free from foreign bodies and humidity in order to protect the device prom premature
wear and tear of the components in movement; therefore, we suggest using a lubricator group for
compressed air.
Topping Up the Oil-Dynamic Circuit
You need to top us the hydraulic circuit after a long period of work, when you note a power loss. Put the
riveting device
(DWELL AND NOT FED)
in a horizontal position and remove the plug
(A),
by means of a 5
mm Allen wrench (equipped with the riveting device); during this operation, check the oil level in order to
avoid overflowing. Then, slowly pour the oil
PANOLIN HLP ISO 32
into the bellows container (
X
) which shall
be screwed into its seat on the plug (
A
). While keeping the riveting device in a horizontal position and
starting air feeding; push the tensile strength button and make the riveting device carry out some cycles
until air bubbles inside the container (
X
) stop coming out. This condition indicates that the topping up of the
oil has fully been achieved. At this point, while keeping the riveting device in a horizontal position, unscrew
the oil container (
X
) and close it again.
Do not push the tensile strength button during this operation.
Go
on by closing the oil tank plug (
A
).
WARNING! It is very important to follow the above-mentioned instructions and use gloves. If the
hydraulic circuit should be fully emptied, collect the oil in a suitable container and contact an authorized
company r its disposal.
WARNING!
•
Before disconnecting the compressed air hose, make sure that it is not under pressure!
•
Make sure that the oil filler cap (A) is tightened at torque corresponding to
Min. 5 Nm
–
Max. 8Nm.
•
We recommend using oil PANOLIN HLP ISO 32 DIN 51524-2HLP or similar.
Device Disposal
For the device disposal, comply with the national laws. After disconnecting the device from energy sources, start the
disassembly of the components according to their material: sheet, aluminium, plastic and so on.
Go on with the scrapping in accordance with the national standards.
