HUCK Seiltechnik GmbH - Dillerberg 3 – 35614 Asslar-Berghausen
[email protected] - www.huck.net
5
63 mm grain size)
In case of sandy and soft soils, the surface measure of foundations have to be enlarged
for about 50 %
Assembly instruction:
1.
Measure out the assembly space including required safety area. Dig out the foundations in accordance
to the foundation plan. Take care that rubble drain bed is 10cm (see sketch).
Attention!
Treat the
wooden parts as described in the enclosed leaflet (maintenance tips for handling the douglas wood).
2.
Lay the cross beam on the ground. (
Attention:
do not remove the steel belt!).
3.
Lay the uprights on the ground and stretch them in accordance to the measurement.
3.1 Before assembling the bolts at the connection of the pair of stand poles and the carriage
bolts of the post shoes have to be retightened.
4.
For stabilization of the scissors position during the installation, fit a temporary lath on the upper edge of
the marking tape and nail it to the upper edge of the playing level! Measuring of the temporary lath is
2.60m (middle post to middle post).
5.
Set down the two scissors frames into the foundation.
6.
Put on the top beam with a projecting end on both sides of 1.49m (fix them rectangular to the uprights
posts; see sketch).
Attention!
The drillings are Ø 17cm in vertical line! Go through the existing drillings of the wood post to
set the drillings on the cross beam. To avoid that the wood tears out while drilling, you should hold a
board against it, secure the cross beam with the 4 bolts
M16 x 360, the washers, the lock nuts and cover caps.
Attention!
The lock nuts have to point to the top!
7.
Set in concrete C20/25 (B25) in accordance with the foundation plan, at least 40cm deep (see enclosed
sketch).
8.
After the setting time (at least 5 days) fix the swing bearing. Take care that bearing is fastened straight,
so that you can attach the play equipment.
For the big Bird´s Nest Art.No. 4650 (bearing on the inside) and for the Huck Honeycomb Art. No. 4550
(bearing on the outside) you always have to fit in the double joint bearing Art. No. 4608-1 (pay attention to
the turn direction of the main bearing: upper axis shows askance to the swing direction; lower axis shows in
swing direction).
We recommend to use a jigsaw with a steel saw blade for the bolt length -adjusting of the joints.
If an angle grinder is used, the surface of the wood can get dark because of chemical reaction
by contact with flying sparks (no impairment to the safety ness and durability of the frame).
Install it with the enclosed safety chain. The safety chain is prepared so that you only have to fit in the eye
bolts (turn direction shows to swing direction) which are installed in the drillings accordance to the
foundation plan. Hang up the free end of the chain on the
second link from the equipment chain (counted from the top) with the already installed shackle. For the
safety swing seat Art. No. 4712 is the simple bearing enough!
Summary of Contents for 4577-1-200
Page 7: ...HUCK Seiltechnik GmbH Dillerberg 3 35614 Asslar Berghausen seiltechnik huck net www huck net 7...
Page 8: ...HUCK Seiltechnik GmbH Dillerberg 3 35614 Asslar Berghausen seiltechnik huck net www huck net 8...
Page 9: ...HUCK Seiltechnik GmbH Dillerberg 3 35614 Asslar Berghausen seiltechnik huck net www huck net 9...
