©
2014 by Huchez Treuils S.A.S.
Translation of the original instructions manual
18
EN
Reproduction prohibited
-
Lubrication
-
The PULLEY-MAN reduction gear is ready greased.
Lubrication used: MoS².
-
Applying the lubrication:
-
Apply grease to the sprocket wheels, rings and shafts.
-
Apply grease or oil to the hook swivel connection.
-
Apply grease to the pressure roller housing tensioners.
-
Dismantle the pulley and apply grease to its shaft.
-
Depending on the frequency of use, re-grease at least once a year as part of the
maintenance programme.
9.2 – Reassembly
For reassembly, follow the dismantling procedure in reverse order and respect the following
points:
-
Do not apply excessive force to the sprocket wheel or shaft.
In general, do not use excessive force or blows that could affect the life of the PULLEY-
MAN and damage its parts and components.
-
Make sure the rings do not deteriorate.
-
Before fixing the sprocket wheel to the flange, first apply a fixing product to the four
(Allen) bolts.
Once the PULLEY-MAN is reassembled, proceed as follows:
-
Use the PULLEY-MAN without a load to see that it is properly assembled.
-
Check that it is not making excessive noise.
-
When no problems are detected, insert the rope.
9.3
Replacing parts and components
Important!
Through daily and periodic checks, replace parts or components whose useful life has
been reached or exceeded with new parts, in accordance with maintenance instructions.
9.3.1.
Rope
Conditions and limits of rope use:
-
Less than 10% of the elementary strands are broken following twisting
(1 step).
-
The diameter of the rope must be reduced by less than 7%.
-
There must be no bends (folded or twisted rope) or corrosion.
-
When the rope is replaced, fix the end with a stop sleeve.
-
The stop sleeve (fixed to one end of the rope to prevent the rope and load slipping off
the pulley due to an excessive load) must be complete, without damage, and there
must be no risk of the rope escaping or becoming separated from it.
Attention !
