03
1.3 HS001 key functions
3
Photo/Video button
Short press to take photos/start and end video recordings.
4
Main Menu key
Short press to enter the Main Menu. Use in conjunction with the +/-
keys to adjust screen brightness/contrast/chrominance/the 5.8GHz
frequency and to check firmware information.
1
Power Switch
Push up/ON to turn on the transmitter. Push down/OFF to turn off.
2
Photo/Video mode
switch button
Photo/Video mode switch button
5
Binding/Clear
screen button
Hold while powering the screen on to initiate a binding. Short press while
the screen is on to clear the screen; short press again to show content.
6
7
TF (Micro-SD) slot
Insert an SD card into the LCD screen’s slot to take and store photos
and video recordings.
8
Charging status LED
While the screen is charging, the LED is a solid red. After charging is
complete, the LED turns solid green.
Micro-USB port
Used for charging and for updating firmware (only when necessary).
No. Key/button/Switch
Function
1.4 Installing the TF (Micro-SD) card
Insert the SD card in the TF card slot located on the display’s right hand side. To eject the SD
card from the slot, push the Micro-SD inwards (it will pop out).
1.5 Charging
The HS001 is paired with a rechargeable 7.4V, 2300mAh Li-Po. Be sure to use the
provided Hubsan dedicated charger for charging. Fully charge the battery before use.
Connect the charger’s USB
adapter to a PC terminal and
then the battery to the charger.
Charging time is approximately
150min; battery life is 120
minutes. Be sure to charge the
battery before each flight.
Make sure the battery is fully charged before each flight.
Please do not leave unattended while charging.
When charging is complete, disconnect the charger and battery from power immediately.
