20
©
2016 Hubsan
哈博森科技 版权所有
1.Transmitter and Q4 do not pair.
Power on the Q4 after the transmitter shows “Bind to Plane”. Close the Transmitter to the
Q4 during binding. Make sure you do not move the transmitter sticks or trim during initial
power-on.
2. Transmitter LED suddenly goes out.
Replace the AA batteries in the transmitter.
3. Trasmitter display is not showing the setting interface after holding down the Elevator stick for
2 seconds.
The throttle stick needs to be in the fully down position.
4. Gyro is not working well.
(1) Battery voltage is too low.
(2) Pair the Q4 with the transmitter again.
(3) Land the Q4 with the throttle stick in the fully down position for 3 seconds and then take off
again.
5. Q4 won't perform flips.
(1) Press and hold down the throttle stick for 1 seconds to enter into flip mode. Do the flip when
the transmitter “beeps”.
(2) LiPo power is too low. Recharge the Q4.
6. Quadcopter is shaking and making noise.
Check that the motors, canopy, body and propellers are all properly positioned.
7. Cannot take off.
(1) Make sure the propellers are installed correctly. The propellers are marked with "A"
(clockwise) and "B" (counterclockwise). Refer to the Top View picture below for the correct
orientation.
(2) Make sure that each motor is installed correctly. There are two different motors with
different motor wire colors. Refer to the Bottom View picture below for the correct order.
H111D TROUBLESHOOTING
Summary of Contents for H111D
Page 1: ...NO H111D Q4 FPV PLEASE READ THE INSTRUCTION MANUAL CAREFULLY BEFORE USE 14...
Page 2: ......
Page 22: ......