Incremental Hollow Shaft Encoder FGHJ 5
14
FGHJ5_MANUAL-en_R4(2018-11-05)ID74524.docx
4.
Mount the torque bracket/torque arm on the housing.
NOTE!
Comply with the information provided in the supplemental data sheet entitled “Mounting
Accuracy of hollow shaft encoders”.
5.
Check the mounting position relative to the terminal box, adjust if necessary.
6.
Push the device onto the shaft that has been lightly greased.
CAUTION!
Danger of damage to shaft and device if improperly handled.
Ensure that there are no hard impacts on hollow shaft and housing.
Use the mounting sleeve.
7.
Fastening Axial tightening disc with 4x M4 on the adapter shaft.
8.
Tighten the fastening screws on the link head of the torque bracket. Fix the nuts in place with
locknuts.
9.
Check the attached torque brackets: The link rod must be easy to turn within the link head,
and the link heads should not tilt. If this instruction is not followed there is a danger of bearing
damage.
10.
Connect the cabling in the terminal box ( Appendix, Connecting diagrams).
