Hubner FGH 8, Operating And Assembly Instructions Manual

Page: 16 / 30

Incremental hollow shaft encoder FGH 8
16
FGH8_MANUAL-en_R6(2018-11-19)ID74584.docx
5.3 Connecting the encoder
5.3.1 Connections
Cable glands are closed with a stopper to protect the devices on transport and storage.
Cable connections:
Have to be executed according to the encoder type.
Connection diagrams have to be considered!
Use of connection cables with diameter of min. 17.5 mm – max. 20 mm is essential to ensure the
protection class. Cable outlet should show preferably downwards.
Option:
R: 12 - pole round plug.
S: Industrial plug
C: Connection cable
Wiring arrangement and shielding
(EMI measurement)
The cable shielding must be placed on both sides.
The shield of the signal cable has to be connected directly to the housing of the encoder by the cable
gland.
You must observe applicable EMC guidelines when routing cables.
Special note!
The connection must be carried out by skilled technical staff only.
Closing the terminal box cover:
Check the seal of the terminal box cover, clean it if soiled. Then duly close the cover.
Note!
Cable must not be pinched.
Attention with open terminal boxes:
Moisture should not get into the terminal box when connecting the cable.
Print-wedges with
operating whip
Cable gland with
plastic pins
Captive fastening
screws
Terminal boxes seal
Terminal box