Hubner FGH 8, Operating And Assembly Instructions Manual

Page: 14 / 30

Incremental hollow shaft encoder FGH 8
14
FGH8_MANUAL-en_R6(2018-11-19)ID74584.docx
5 Installation and commissioning
5.1 Safety instructions
Personnel
Installation and commissioning must be carried out by skilled technical staff only.
NOTES!
Observe the safety instructions contained in Chapter 2 when installing or working on the
device!
5.2 Mounting of the encoder (mechanical)
Mounting and disassembly by means of a hammer or similar tools in not permitted (warranty void).
5.2.1 Mounting Instruction for hollow shaft encoder
1.
Adapter flange has to be mounted and to be aligned by dial gauge, if necessary optimize by
ball thrust adjusting screws.
2.
Ball thrust screws to be fastened with Loctite, remove non-fastened screws of fasten with
Loctite! Max. torque for M12 approx. MD 25 Nm / M16 approx. MD 35 Nm.
The hollow shafts has tapped holes on both sides at the front. For removal use screws to attach the
mounting sleeve, and then use a puller to draw off the unit. A suitable mounting sleeve is
recommended for each plant area (specify on ordering). Remove hollow shaft encoders using
mounting sleeve only:
Fig. 1
Fig. 2