Huber MPC RotaCool, Operation Manual

Page: 33 / 52

Function description
Chapter 3 OPERATION MANUAL
V2.3.0en/04.08.21//1.30
RotaCool®
33
3.5 Menu function
Your temperature control unit is equipped with a menu function.
Menu item Display Description
ADR Without a function
C40 Auto-Start function
PA Service menu
Only for Huber service personnel.
--
3.6 Function examples
3.6.1 Display setpoint
PROCEDURE

Press the >SET key< [D] and keep it pressed. The setpoint is displayed.

Release the >SET key< [D]. The internal temperature is displayed again.
3.6.2 Set/change setpoint
PROCEDURE

Press the >SET key< [D] and keep it pressed. The setpoint is displayed.

Use the >Arrow keys< [C] to select the required value.
(up) the temperature increases, (down) the temperature decreases.

Release the >SET key< [D]. The new setpoint is set.
3.6.3 Changing the Auto-Start function
Following a power outage (or when switching on the temperature control unit), this function can be
used to determine how the temperature control unit is supposed to respond.
Auto-Start function is turned off
The temperature control is started only by manual input when the temperature control unit is
turned on.
Auto-Start function is turned on
The temperature control unit is set to the same state it was in before the power outage. For exam-
ple, before the power outage: Thermoregulation is off; after power outage: Thermoregulation is off.
If temperature control is active during a power outage, the process will automatically continue after
the power outage.
Setting Display Description
0 The auto-start function is turned on.
1 The auto-start function is turned off.
Overview of the menu
items
Settings in the menu
item “C40” auto-start
function