Huber MPC RotaCool, Operation Manual

Page: 25 / 52

Commissioning
Chapter 2 OPERATION MANUAL
V2.3.0en/04.08.21//1.30
RotaCool®
25
2.3.1 EMC-specific notes
Connecting cables in general
Prerequisites for a failure-free operation of the temperature control units incl. their connections
with external applications: Installation and wiring must be carried out professionally. Related
topics: "Electrical safety" and "EMC-compliant wiring".
Cable lengths
For flexible/fixed cable routing of more than 3 meters, the following must amongst other things be
observed:
- Equipotential bonding, grounding (see also technical data sheet "Electromagnetic compatibility
EMC")
- Compliance with "external" and/or "internal" lightning/overvoltage protection.
- Design protection measures, professional cable selection (UV resistance, steel pipe protection,
etc.)
Attention:
The operating company is responsible for compliance with national/international directives and
laws. This also includes the testing of the installation/wiring required by law or standards.
This device is suitable for operation in
“industrial electromagnetic environments”
. It meets the
“immunity requirements”
of the currently applicable
EN61326-1
, which are required for this envi-
ronment.
It also meets the
“interference emission requirements”
for this environment. It is a
Group 1
and
Class A
device according to the currently applicable
EN55011
.
Group 1
specifies that high frequency (HF) is only used for the function of the device.
Class A
defines
the interference emission limits to be observed.
2.4 Installation conditions
Temperature control unit is connected to the power supply line
DEATH FROM ELECTRICAL SHOCK BY DAMAGE TO THE POWER CABLE.

Do not put temperature control unit on power cable.
Operating the temperature control unit fitted with casters without brakes activated
CRUSHING OF LIMBS

Activate brakes on the casters.
▪ Allow the temperature control unit to acclimate for about 2 hours when changing from a cold to a
warm environment (or vice versa). Do not turn on the temperature control unit before!
▪ Install upright, stable and tilt-resistant.
▪ Use a non-combustible, sealed foundation.
▪ Keep the environment clean: Prevent slip and trip hazards.
▪ Wheels, if installed, must be locked after installation!
▪ Spilled/leaked thermal fluid must be removed immediately. Observe the proper disposal of ther-
mal fluid and aids. → Page 15, section »Proper disposal of resources and consumables« .
▪ Observe the floor load bearing capacity for large units.
▪ Observe the ambient conditions.
2.5 Recommended temperature control hoses
Use of unsuitable/defective hoses and/or hose connections
INJURIES

Use appropriate hoses and/or hose connections.

Check periodically for leaks and the quality of the hose and hose connections and take suitable
measures (replace) as required.

Isolate and protect temperature control hoses against contact/mechanical load.