Huber MPC Minichiller 280, Manual

Page: 24 / 60

Commissioning
OPERATION MANUAL Chapter 2
Minichiller®
V2.4.0en/09.08.21//1.30
24
2.1.3 Positioning the temperature control unit
2.1.3.1 Temperature control unit with casters
▪
Do
not
use the casters for the transportation to the place of installation. → Page 22, section
»Lift-
ing and transporting the temperature control unit«
.
▪ Use the casters only for positioning at the place of installation.
▪
Only ever move the temperature control unit on the casters if the surface is level, without gradi-
ent, non-slip and stable.
▪ Do not move the temperature control unit alone.
▪ At least 2 persons
are required to move the temperature control unit on casters.
At least 5 per-
sons
are required to move the temperature control unit on the casters if the total weight of the
temperature control unit is
over 1.5 tons
.
▪ The parking brakes must be activated at the casters and/or the feet (if present) must be un-
screwed/activated before the temperature control unit is put into operation. → Page 30, section
»Unscrewing/activating the leveling feet (if any)« .
2.1.3.2 Temperature control unit without casters
▪
An industrial truck must be used for positioning the temperature control unit.
▪ Do not move the temperature control unit alone.
▪ At least 2 persons
are required to move the temperature control unit.
▪ The industrial truck must have a lifting force equal to or greater than the weight of the tempera-
ture control unit. See the data sheet for the weight of the temperature control unit. → From page
59, section »Annex« .
▪
The leveling feet (if present) must be unscrewed/activated before the temperature control unit is
put into operation. → Page 30, section
»Unscrewing/activating the leveling feet (if any)«
.
2.2 Unpacking
Starting up a damaged temperature control unit
DANGER TO LIFE FROM ELECTRIC SHOCK

Do not operate a damaged temperature control unit.

Please contact Customer Support. → Page 58, section »Contact data« .
PROCEDURE

Check for damage to the packaging. Damage can indicate material damage to the temperature
control unit.

Check for any transport damage when unpacking the temperature control unit.

Always contact your forwarding agent regarding the settlement of claims.

Observe the proper disposal of packaging material. → Page 15, section »Proper disposal of
resources and consumables« .
2.3 Ambient conditions
Unsuitable ambient conditions / unsuitable installation
SERIOUS INJURY DUE TO CRUSHING

Comply with all requirements! → Page 24, section »Ambient conditions« and → Page 26,
section »Installation conditions« .
Make sure there is adequate fresh air available at the site for the circulation pump and the com-
pressors. The warm exhaust air must be able to escape upwards unhindered.
Free-standing models
For the connection data, see the data sheet. → From page 59, section »Annex« .