Commissioning
OPERATION MANUAL
Chapter 2
CC®-Immersion circulator
V2.4.0en/08.12.20//17.12
20
2.1.3
Positioning the temperature control unit
2.1.3.1
Temperature control unit with casters
▪
Do
not
use the casters for transportation to the place of installation. Observe page 18, section
»Lifting and transporting the temperature control unit«
for the transport to the place of installa-
tion.
▪
Use the rollers only for positioning at the place of installation.
▪
Only ever move the temperature control unit on casters if the surface is level, without a gradient,
non-slip and stable.
▪
Do not move the temperature control unit alone.
▪
At least 2 persons
are required to move the temperature control unit on casters.
At least 5 per-
sons
are required to move the temperature control unit on casters if the total weight of the tem-
perature control unit is
over 1.5 tons
.
▪
The parking brakes must be activated at the casters and/or the leveling feet (if any) must be un-
screwed/activated before the temperature control unit is put into operation (see page 25, section
»Unscrewing/activating the leveling feet (if any)«
).
2.1.3.2
Temperature control unit without casters
▪
An industrial truck must be used for positioning the temperature control unit.
▪
Do not move the temperature control unit alone.
▪
At least 2 persons
are required to move the temperature control unit.
▪
The industrial truck must have a lifting force equal to or greater than the weight of the tempera-
ture control unit. See the data sheet (from page 73 in section
) for the weight of the
temperature control unit.
▪
The leveling feet (if any) must be unscrewed/activated before the temperature control unit is put
into operation (see page 25, section
»Unscrewing/activating the leveling feet (if any)«
).
2.2
Unpacking
Starting up a damaged temperature control unit
MORTAL DANGER FROM ELECTRIC SHOCK
Do not operate a damaged temperature control unit.
Please contact the Customer Support. The telephone number can be found on page 72, section
.
PROCEDURE
Check for damage to the packaging. Damage can indicate property damage to the temperature
control unit.
Check for any transport damage when unpacking the temperature control unit.
Always contact your forwarding agent regarding the settlement of claims.
Follow the instructions for the disposal of packaging material on page 15 section
posal of resources and consumables«
.
2.3
Ambient conditions
Unsuitable ambient conditions/unsuitable installation
SERIOUS INJURY DUE TO CRUSHING
Comply with the requirements under sections
and
.
Make sure there is adequate fresh air available at the site for the circulation pump and the com-
pressors. The warm exhaust air must be able to escape upwards unhindered.
Free-standing model
For the connection data, see the data sheet (from page 73 in Section
).
