SECTION 1: INSTALLATION
WARNING
This product may only be installed by a qualified electrical engineer. The unit
is not designed to be installed upside down or sideways on a wall.
The AM-2 is designed to be wall-mounted or installed flat inside a cabinet. When installing on a
wall ensure you use Rawl boats to secure the unit to the wall.
DIP SWITCH SETTINGS
Configure each battery address to enable proper setup and communication. Each battery needs
a unique serial address in order to communicate. If you are only using one battery in your setup,
ensure you set the battery to Address 1.
Page 2
DC ISOLATOR
The Hubble AM series of batteries has an integrated electronic circuit breaker built into the BMS.
The integrated electronic CB is for protecting the battery and the internal cells against overload,
over current, over volt etc. It is however required to install an external DC fuse or circuit breaker
before using or operating the batteries. Please ensure you use the correct rating as per battery
specification.
