Page 3 Kim Lighting • 16555 E. Gale Ave. • P.O. Box 60080 • City of Industry, CA 91716-0080 • 626/968-5666 • FAX 626/330-3861
LIGHTVAULT
®
LENS REFLECTOR - LTV59/759
Installation Instructions
LAMP / MAINTENANCE INSTRUCTIONS:
Make certain electrical supply is OFF before starting lamp installation.
!
1. To replace lamp remove eyeball lens frame & gasket with lens.
2. Replace lamp of type and wattage as shown on
fixture label. NOTE: After installing lamp let fixture
warm up for 5 minutes before completely closing.
Coat screws with silicone
grease and tighten
opposing screws
progressively and evenly
until tight.
MAINTENANCE:
▼
A regularly scheduled maintenance program must be established to keep fixtures clean. Dried leaves and paper
can burn if allowed to accumulate on high temperature lenses. A buildup of dirt and other material on the lens may
cause excessive temperatures within the fixture.
▼
High-temperature lenses which can burn feet, hands, or objects inadvertently placed on top of fixtures.
▼
Clean lens gasket and frame inside and out. Before closing fixture, be sure gasket and gasket surfaces are clean
and dry. Make sure no dirt has fallen into screw holes.
▼
Install lens gasket and lens frame. Coat screws with silicone grease and tighten progressively and evenly until tight.
WARNING:
This H.I.D. / Fluorescent fixture utilizes a lamp that may
contain mercury. For information on disposal of lamp go
to website: www.lamprecycle.org
3. Before closing fixture, clean lens and gasket inside
and out. Be sure gasket surface is dry. Make sure
no dirt has fallen into screw holes. Any foreign
object trapped in the gasket will create potential
points of entry for ground water.
Lens Frame
Gasket with Lens
1
2
3
4
