Pub. 42004-484G
Clean Phone
®
Analog Telephones
Page 4 of 26
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-484G.docx
04/19
Operation
Placing an Autodial Call
To place an autodial call:
1.
Press the desired autodial push button to place an immediate call to a preprogrammed number.
The hookswitch indicator lights when the call is connected.
2.
Terminate the call by:
•
pressing the ON/OFF push button
•
hang up of the called number
•
exceeding the duration of the call timeout.
Placing a General Telephone Call
To place a general telephone call:
1.
Press the ON/OFF push button.
2.
Wait for the dial tone.
3.
Use the keypad to dial the desired number.
The
off-hook
indicator lights when the call is connected.
4.
Terminate the call by:
•
pressing the ON/OFF push button
•
hang up of the called number
•
exceeding the duration of the call timeout
Receiving a Call
The Clean Phone
®
analog telephone automatically goes off-hook (auto-answers) when the unit is called.
This is the default operating mode. The Clean Phone
®
analog telephone can be programmed for manual
answer (see the Off-Hook Ringing section).
Installation
General Information
WARNING
—This product can contain hazardous voltages. Always remove power to this
station and any associated equipment before beginning any installation.
CAUTION
—Do not install this equipment in areas other than those indicated on the approval
standards listing in the Approvals section of this manual. Such installation may
cause a safety hazard and consequent injury or property damage.
Install equipment without modification and according to all applicable local and national electrical codes.
Consult the National Electrical Code (NFPA 70), Canadian Standards Association (CSA 22.1), and local
codes for specific requirements regarding your installation. Class 2 circuit wiring must be performed in
accordance with NEC 725.55.
