P817-1187 Rev A
17
8—Operation
Energizing, Exercising &
Inspecting
Step 1. — Turn On Power
• Turn the power supply “ON” at the fuse/
breaker box if applicable
• Refer to Figure 9
• Turn control box main power switch “ON”
• Status lights for “POWER” and switch
“CLOSE” will illuminate
Step 2. — Exercising Overhead
Switch
• Place local/remote switch in local
position
• Open overhead switch by pressing the
“OPEN” push-button
• Close overhead switch by pressing the
“CLOSE” push-button
• Observe status light functions:
– “OPEN” illuminated when overhead
switch is open
– “CLOSE” illuminated when overhead
switch is closed
• If status light indication is opposite over-
head switch position, review “Reversing
Motor Operator Rotation” in the Pre-Op-
eration Checks section and correct as nec-
essary
Step 3. — Inspecting Overhead
Switch
• Cycle the overhead switch 8 to 10 times
• Thoroughly inspect overhead switch for
proper opening and closing
• If overhead switch does not fully/ad-
equately open or close, proceed to the
section on Adjustment, and return to Step
4 below
Step 4. — Set Local/Remote
Operating Mode
• Place local/remote switch in desired posi-
tion
Moving parts.
Can cause severe injury.
Do not operate motor operator until hands and clothing are clear of all
moving parts.
Hazardous voltage.
Electrical contact with system voltage will cause severe injury or death.
Do not exercise overhead switch while it is energized.
!
WARNING
!
DANGER
Figure 9 – Control Box Switches
Additional Functions
Battery Test
Press and hold the “Battery Test” switch for 10
seconds. The “Low Battery Alarm” will illumi-
nate if there is a battery problem.
Lamp Test
Press and hold the “Lamp Test” switch.
All control box lights will illuminate.
