12
©2017 Hubbell Incorporated | Chance
®
Full Range ARVI Operating Instructions
Hold Mode (for Overhead and Underground)
The Full-Range ARVI has a hold feature (Hold Mode) built into the circuitry, which automatically holds
a reading when the unit is left on an energized conductor or senses constant voltage for a period of
approximately 15 seconds. In the Hold Mode, the LED representing the voltage range being indicated
will become solid. The audible beeping will become continuous for 1 to 2 seconds followed by 5 to 6
very rapid beeps, then 1 to 2 seconds of silence. The unit then will return to the normal audible mode,
but one LED will remain solid until reset.
To reset the unit after a held reading is displayed:
Remove the unit from the conductor and press and hold the "Power Button" until you hear three rapid
beeps then release. If you hold the "Power Button" for too long then you will hear two series of three
rapid beeps (six beeps total), which means the unit is powered off. You will then need to turn the unit
back on.
Once in the Hold Mode, the unit must be reset for the LEDs to indicate higher or lower voltages.
!
CAUTION
In the Hold Mode, the unit is waiting for a steady (consistent) voltage reading before holding a
reading. Loss of contact with the conductor during the Hold Mode will cause a delay in capturing
the reading.
!
CAUTION