J-Box Mounted Emergency Light
CJB
IMPORTANT SAFEGUARDS
WARNING:
RISK OF ELECTRIC SHOCK- NEVER CONNECT TO, DISCONNECT FROM,
OR SERVICE WHILE EQUIPMENT IS ENERGIZED.
WARNING:
FAILURE TO FOLLOW THESE INSTRUCTIONS AND WARNINGS MAY
RESULT IN DEATH, SERIOUS INJURY OR SIGNIFICANT PROPERTY DAMAGE.
For your protection, read and follow these warnings and instructions carefully before
installing or maintaining this equipment. These instructions do not attempt to cover all
installation and maintenance situations.
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1.
Rated for temperature range of 10℃ to 40℃ (50℉ to 104℉).
2.
Used indoors only.
3.
Equipment should be mounted in locations and at heights where it will not be subject to
tampering by unauthorized personnel.
4.
Do not mount near gas or electric heaters.
5.
The use of accessory equipment is not recommended by the manufacturer and may cause
an unsafe condition.
6.
Do not use this equipment for anything other than its intended use.
7.
Servicing of this equipment should be performed by qualified personnel.
8.
Disconnect AC power before servicing.
INSTALLATION
I
PAC6060W-P PAC6060W-E
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
Rated for temperature range of 10� -40� (50� -104� ) .
2.
Used indoors only.
3.
Equipment should be mounted in locations and at heights where it will not be subject to tampering by unauthorized
personnel.
4.
Do not mount near gas or electric heaters.
5.
The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe condition.
6.
Do not use this equipment for anything other than its intended use.
7.
Servicing of this equipment should be performed by qualified personnel.
8.
Disconnect AC power before servicing.
SAVE THESE INSTRUCTIONS!
INSTALLATION (J-BOX MOUNTING)
1.
Connect the battery wire.
（
Fig 1
，
Fig 2
）
2.
Connect input wire of 120/277 to AC power
（
universal voltage from 120V-277V
），
then put the whole unit into J-box,
fix it by using screws on corner, then put on the face cover. (Fig 3)
3.
Turn on the AC power and press the "TEST" button to check the light.
Fig 1
Fig 2
INSTRUCTION FOR EMERGENCY
LIGHTING FIXTURE
IMPORTANT!
The battery in this unit may not be fully charged. After
electricity is connected to unit, let battery charge up for at
least 24 hours. Then the normal operation of this unit should
take effect. To check, press the "TEST” button and the lights
on the unit should turn ON.
I
PAC6060W-P PAC6060W-E
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
Rated for temperature range of 10� -40� (50� -104� ) .
2.
Used indoors only.
3.
Equipment should be mounted in locations and at heights where it will not be subject to tampering by unauthorized
personnel.
4.
Do not mount near gas or electric heaters.
5.
The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe condition.
6.
Do not use this equipment for anything other than its intended use.
7.
Servicing of this equipment should be performed by qualified personnel.
8.
Disconnect AC power before servicing.
SAVE THESE INSTRUCTIONS!
INSTALLATION (J-BOX MOUNTING)
1.
Connect the battery wire.
（
Fig 1
，
Fig 2
）
2.
Connect input wire of 120/277 to AC power
（
universal voltage from 120V-277V
），
then put the whole unit into J-box,
fix it by using screws on corner, then put on the face cover. (Fig 3)
3.
Turn on the AC power and press the "TEST" button to check the light.
Fig 1
Fig 2
INSTRUCTION FOR EMERGENCY
LIGHTING FIXTURE
IMPORTANT!
The battery in this unit may not be fully charged. After
electricity is connected to unit, let battery charge up for at
least 24 hours. Then the normal operation of this unit should
take effect. To check, press the "TEST” button and the lights
on the unit should turn ON.
I
PAC6060W-P PAC6060W-E
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
Rated for temperature range of 10� -40� (50� -104� ) .
2.
Used indoors only.
3.
Equipment should be mounted in locations and at heights where it will not be subject to tampering by unauthorized
personnel.
4.
Do not mount near gas or electric heaters.
5.
The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe condition.
6.
Do not use this equipment for anything other than its intended use.
7.
Servicing of this equipment should be performed by qualified personnel.
8.
Disconnect AC power before servicing.
SAVE THESE INSTRUCTIONS!
INSTALLATION (J-BOX MOUNTING)
1.
Connect the battery wire.
（
Fig 1
，
Fig 2
）
2.
Connect input wire of 120/277 to AC power
（
universal voltage from 120V-277V
），
then put the whole unit into J-box,
fix it by using screws on corner, then put on the face cover. (Fig 3)
3.
Turn on the AC power and press the "TEST" button to check the light.
Fig 1
Fig 2
INSTRUCTION FOR EMERGENCY
LIGHTING FIXTURE
IMPORTANT!
The battery in this unit may not be fully charged. After
electricity is connected to unit, let battery charge up for at
least 24 hours. Then the normal operation of this unit should
take effect. To check, press the "TEST” button and the lights
on the unit should turn ON.
NOTE:
1. Before installation, use a tool to remove the faceplate. (Fig 1)
4.
(Fig 4)
(Fig 2, Fig 3)
1. Before installation, use a tool to remove the faceplate. (Fig 1)
4.
(Fig 4)
(Fig 2, Fig 3)
1. Before installation, use a tool to remove the faceplate. (Fig 1)
4.
(Fig 4)
(Fig 2, Fig 3)
