11
The above adjustment is used for setting of default information that is distinguished by the
value of “stop frequency”. Actually, adjustment is generally performed as required during
the first time use in practical application and is not performed later unless there is
regulation or special requirement.
3
、
Change of Sweeping Parameters
Change of sweeping parameters is used for testing of complicated parameter
combinations. The system doesn’t have memory function and will recover automatically
once quit.
Click parameter label in the curve display area (A) before sweeping to change information
other than stop frequency in the manner of cyclic adjustment.
Change of sweeping parameters is applicable to single test with measuring result
requirement or for the sake of research, generally not requiring adjustment.
Test
You may start data measurement with frequency response method after setting of basic
test information. The system will automatically complete frequency sweep after “START”
key is clicked. The
key will turn to
key in the process of test that could stop the
current sweeping once clicked. The test pauses once the signal curve display area is
clicked and proceeds when clicked again.
After completion of a test item, change the wiring mode, change software setting
information, click again
key, measure the next item and repeat the above operations
until all measurement items are completed.
The test waveform display area is unfolded when the test curve display area (A) is double
