Step 6
Check that the new cable is properly connected.
Power on the server. If the LOM indicator is green, the cable is properly connected.
Step 7
Bind the new optical cable.
Bind the new optical cable in the same way as existing optical cables. You can also remove all
cable ties and bind all of the optical cables again if necessary.
----End
4.5.6 Connecting a USB Device
Step 1
Wear an ESD wrist strap. For details, see
12 Preventing Electrostatic Discharge
.
Step 2
Connect the USB device to a USB port on the server. See
Figure 4-21
Connecting a USB device
----End
4.5.7 Connecting a Serial Cable
The rear panel of the server provides one standard RJ45 serial port, which works as the
system serial port by default. You can set it as the iBMC serial port by using the iBMC CLI.
The serial port can be used as:
l
System serial port to monitor the OS status
l
iBMC serial port for debugging and fault locating
2288H V5 Server
User Guide
4 Setup
Issue 04 (2018-09-04)
Copyright © Huawei Technologies Co., Ltd.
88