Operation Manual - System Management
Quidway S3500 Series Ethernet Switches
Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-22
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
Perform the following operation in system view:
Table 4-37
Configuring the output format of time-stamp
Operation
Command
Configure the output format of
the time-stamp
info-center timestamp
{
log | trap
|
debugging
} {
boot
|
date
|
none
}
Output time-stamp is disabled
undo info-center timestamp
{
log
|
trap
|
debugging
}
4.5.7 Sending the Configuration Information to Trap Buffer
To send configuration information to trap buffer, follow the steps below:
1) Enabling
info-center
Perform the following operation in system view.
Table 4-38
Enabling/disabling info-center
Operation
Command
Enable info-center
info
-
center enable
Disable info-center
undo info
-
center enable
Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2)
Configuring to output information to trap buffer
Perform the following operation in system view.
Table 4-39
Configuring to output information to trap buffer
Operation
Command
Output information to trap buffer
info
-
center trapbuffer
[
size buffersize
]
[
channel
{
channel
-
number | channel
-
name
}
]
Cancel the configuration of
outputting information to trap
buffer
undo info
-
center trapbuffer
[
channel
|
size
]