18
Installing Boards
1
Loosen the screws on the filler panel and remove the filler panel.
Hold the ejector levers on the panel with hands and raise them to form an angle of approximately 45 degrees
between the ejector levers and the panel. Push the board gently along the guide rail until the board is secure .
Lower the two ejector levers of the board.
Tighten the screws on the panel.
Before installing and removing/inserting a board, wear an ESD wrist strap or ESD gloves. Before you insert a
board, ensure that the slot is correct. If it is difficult to insert the board, stop the operation.
2
3
4
When installing a PGND cable in the ETSI cabinet,
connect the PGND cable to the ground point on
the left side of the chassis.
When installing a PGND cable in the 19-inch
cabinet, connect the PGND cable to the ground
point of the left mounting ear of the chassis.
1
Installing PGND Cables
Installing IDU Cables
Guide rail
NOTE
