Huawei OptiX OSN 6800, Hardware Description

Page: 78 / 92

OptiX OSN 8800/6800/3800
Hardware Description
4 OptiX OSN 8800 Subrack
Issue 01 (2016-03-10) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
76

The TN18EFI board has a set of five DIP switches whose IDs are ID1-ID5 from the
lower bit to the higher bit. Each DIP switch can be used to set a binary digit, 0 or 1.
When the DIP switch is toggled to
0 , the value of the corresponding bit is set to 0. DIP
switches must be toggled to the topmost or the bottommost. Otherwise, the subrack ID
cannot be intuitively identified.

A maximum of 32 states can be set. The value is 00000 by default. "0" indicates the
master subrack. The other values indicate slave subracks. As shown in
Figure 4-31 , the
value represented by the ID5-ID1 is 00001, which is 1 in decimal system. That is, the
subrack ID is 1.
Figure 4-31 Position of the DIP switches on the board panel (type B)
ID4 ID3ID2 ID1 ID5
NM_ETH1 ALMI1 ALMO1 ALMO2
NM_ETH2
ID5 ID4
ID3ID2ID1
1
0
1
0
Figure 4-32 shows the mapping between the DIP switch binary values and subrack IDs.