Before installing boards and daughter cards, ensure that the device and cabinet are adequately grounded.
Before handling a board or daughter card, wear a grounded ESP strap to avoid electrostatic damage to components.
Warning
Slot Assignment
Install a board
1
2
1
2
3
3
Install a daughter card
Installing Boards and Daughter Cards
Determine the slot for the board to be installed based on hardware planning and remove the filler panel from the slot.
Extend the ejector levels of the board, insert the board fully into slot, and rotate the ejector level to the front of the board so
that the board is fully inserted in the slot.
Use a Phillips screwdriver to tighten the captive screws to the board.
Remove the filler panel from the board.
Smoothly insert the daughter card into the board along the guide rail.
Use a Phillips screwdriver to tighten the captive screws to the board.
2
3
1
1
3
2
a
b
4/5
3
2
1
AUX
ACT
MPU
NIP-MPU-X3
RUN
ALM
ACT
RESET
OFL
LINK
CLK
TOD
MGMT-ETH
CONSOLE
AUX
ACT
MPU
NIP-MPU-X3
RUN
ALM
ACT
RESET
OFL
LINK
CLK
TOD
MGMT-ETH
CONSOLE
OFF
ON
~100-120V;
~200-240V;
50/60Hz;16A
20
OFF
ON
~100-120V;
~200-240V;
50/60Hz;16A
20
MPU
MPU
LPU/SPU
LPU/SPU
LPU/SPU
4
5
3
2
1
7