Huawei IN200, User Manual

Page: 126 / 142

Command Function
ethtool -N ethx Configures the RSS rule.
ethtool -x ethx Query the indirect table.
ethtool -X ethx Configures the indirect table.
ethtool -P ethx Displays the fixed MAC address.
ethtool -l ethx Queries the number of queues.
ethtool -L ethx Configures the number of queues.
Some ethtool standard commands are not applicable to an IN200, and their functions are
substituted by hinicadm. For example:
l ethtool -e: provides the eeprom burning function, which is used in NIC firmware
update. For an IN200, ethtool -e is substituted by the
updatefw command of hinicadm.
l ethtool -d: provides the chip register dump function, which is used to collect chip
location information. For an IN200, ethtool -d is substituted by the
hilink_dump
command of hinicadm.
Table 6-3 lists the common ifconfig commands supported by the IN200 and their functions.
For details about how to use the commands, see the help information provided on the CLI.
Table 6-3 Common ifconfig commands
Command Function
ifconfig ethx hw Configures the NIC address.
ifconfig ethx mtu Configures the network port MTU.
ifconfig ethx [-]allmulti Enables or disables the full multicast feature.
ifconfig ethx [-]promisc Enables or disables the promiscuous mode.
Table 6-4 lists the common ip link commands supported by the IN200 and their functions. For
details about how to use the commands, see the help information provided on the CLI.
Table 6-4 Common ip link commands
Command Function
ip link set dev ethx vf <num> <mac
addr> Sets the MAC address of the virtual network port.
ip link set devethx vf <num> vlan
<vlan_id> qos <vlan-qos> Sets the VLAN ID and QoS priority of the virtual
network port.
Huawei IN200 NIC
User Guide
6 Management Tools
Issue 06 (2019-07-27) Copyright © Huawei Technologies Co., Ltd. 117