HUAWEI UMTS M2M Module V100R001
AT Command Interface Specification
Issue 18 (2009-06-22)
Commercial in Confidence
Page 62 of 169
<fo> depending on the command or result code: first octet of 3GPP TS 23.040 [3] SMS-DELIVER,
SMS-SUBMIT (default 17), SMS-STATUS-REPORT, or SMS-COMMAND (default 2) in integer
format
<mr> Message-Reference.
<ra> Recipient-Address
<tora>address type
<scts>Service-Centre-Time-Stamp.
<dt> Discharge-Time.
<st> Status.
5.7 New message notification sCNMI
5.7.1 Command Syntax
Command
Possible response(s)
+CNMI=[<mode>[,<
mt>[,<bm>[,<ds>[,
<bfr>]]]]]
<CR><LF>OK<CR><LF>
In case of SMS-related error:
<CR><LF>+CMS ERROR: <err><CR><LF>
+CNMI?
<CR><LF>+CNMI:
<mode>,<mt>,<bm>,<ds>,<bfr><CR><LF><CR><LF>OK<C
R><LF>
+CNMI=?
<CR><LF>+CNMI: (list of supported <mode>s),(list of
supported <mt>s),(list of supported <bm>s),(list of supported
<ds>s),(list of supported <bfr>s)
<CR><LF><CR><LF>OK<CR><LF>
5.7.2 Description
The “SET” command is used to set the program of reporting new message to TE,
where,
<mode> and <bfr> are used to set the mode of reporting the new message notification
(including four types: +CMT, +CMTI, +CDSI, +CDS) to the TE.
<mt> is used to set whether reporting the new message to the TE, or storing the new
message in the MS and reporting the storage position when a new message is
received.
<bm> is not in use currently.
<ds> is used to set whether to report the message state report (+CDSI, +CDS).
The TEST command returns the supported parameter values.
Summary of Contents for EM770W
Page 2: ......
