6
Unpacking and Accepting Products
Unpacking
Unpacking the Carton
Read the carton label to obtain the information about the number and the type of the products in the carton.
Items to check for before unpacking the products are shown in the following table.
• The project supervisor must check the products on site in the presence of the customer.
• If the package is damaged, stop unpacking and report the condition of the package to a local Huawei
representative. If the quantity of the product is correct and the product is in good condition, unpack and accept
the product.
• In general, cartons are used to pack products (such as cables, terminal devices and associated devices).
• Cut the tapes along the seams of the carton cover by using a knife. Make sure that you cut only the tapes
without damaging the contents of the carton.
• If the products are wet or rusty, stop unpacking and detect the cause. Report the condition of the products to a
local Huawei representative.
Use a knife to cut the pressure-sensitive adhesive tapes along the seams of the carton cover.
Open the carton and take out the foam plates.
Take the products out of the carton.
Place the unpacked products in a safe place to avoid damage.
No.
Description
1
The destination address is the same as the address of the installation site.
2
The packing device is in proper condition. It should not be damaged or damp.
3
The total number of packages is consistent with the number of items mentioned in the packing list
attached to the packing device.