4
4. After the PON terminal is installed with a foot-stand, do not remove the foot-stand unless
it is necessary. When you remove the foot-stand, apply force evenly on the two sides of
the foot-stand to avoid damages to the PON terminal.
5. Use of controls or adjustments or performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Mounting a GPON terminal on the desk
The figure blow uses an HG8247H as an example to show the ONT that is horizontally placed on a desk.
Mounting a GPON terminal onto the wall
(Only supported by some product models)
Step 1
Mark the positions of two holes used for mounting a GPON terminal, ensure that the
two holes have the same spacing as the two mounting holes.
Step 2
Select a proper drill according to the outer diameter of the screws. Use a hammer drill
to drill the marked positions on the wall. Then clean the wall and install two expansion
bolts.
Step 3
Use a screwdriver to fasten the screws into the expansion bolts, leaving the heads of
the screws 3 mm over the wall. Then install the GPON terminal to the screws.
2
1. Mark the installation positions.
2. Drill two holes and install
expansion bolts.
3. Install screws and the GPON terminal.
1
2
4
3
1
3 mm
