5
5.3 Wall-Mount Device Installation
1
Take six M4*6 screws. Use three screws to configure one mounting ear on the left of the front
panel and the same way to configure the other ones on the right side. Use a Phillips screwdriver to
fasten the screws used to fix the mounting ears, as shown in the lower-left figure.
2
Mark the installation position. Mark the four installation holes on the wall. The vertical distance
among holes is 32 mm and horizontal distance is 465 mm. Then use a plumb line to check whether
the holes are horizontal, as shown in the lower-right figure.
5.2.2 Multi-Device Deployment Scenario
Note:
For details about how to install a device in the cabinet, see the single-device deployment scenario.
This section introduces how to install multiple devices in the cabinet
When multiple decoders need to be installed, the decoders can be stacked, and no space needs to be
reserved between each two decoders, as shown in the following figure.
