Huawei CX600-16, Hardware Description

Page: 127 / 132

Table 4-26 Buttons and indicators on the panel of the SRU
Indicator/
Button Description
OFL button To remove a board, you must press and hold the button for six seconds
until the OFL indicator turns on.
This button takes effect only on the slave SRU.
OFL indicator
(red) If the indicator is on, you can remove the board.
RUN indicator
(green) If the indicator blinks once every two seconds (0.5 Hz), the system is in
the normal state.
If the indicator blinks twice each second (2 Hz), the system is in the
alarm state.
ALM indicator
(red) If the indicator is steady on, the system is in the alarm state.
If the indicator is steady off, the system is in the normal state.
ACT active/
standby indicator
(green) If the indicator is steady on, the SRU is in the active state.
If the indicator is off, the SRU is in the standby state.
Reset button If you press the Reset button, you can reset the main control unit on the
SRU.
CF ACT indicator
(green) If the indicator is on, the CF is in position.
If the indicator is blinking, data is being read or written.
If the indicator is off, the CF is not in position or can be removed.
CF OFL button If you press the CF OFL button, all operations on the CF card will be
ended and the CF card will be powered off.
SFP LINK/ACT
indicator (green) If the indicator is steady on, the link is normal.
If the indicator is blinking, data is being transmitted.
MGMT-ETH
LINK indicator
(green) (on
Ethernet
interfaces) If the indicator is steady on, the link is normal.
If the indicator is off, the link is Down.
MGMT-ETH
ACT indicator
(amber) (on
Ethernet network
interfaces) If the indicator is blinking, data is being transmitted.
If the indicator is off, no data is being transmitted.
Table 4-27 lists the interfaces on the SRU and their uses.
HUAWEI CX600-8/16/X3/X8/X16 Metro Service Platform
Hardware Description
4 CX600-X8
Issue 03 (2013-11-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
108