Installing Cables
b
c
d
e
f
2. The optical fiber connection of AP6610DN is similar to that of WA653SN. Here, WA653SN is used as an example.
Connect the optical fiber to the AP and ensure that the waterproof connector is fastened.
CAUTION
●
Connecting the feed line
1. The outdoor AP's antenna ports already have 5 KA surge protection capability. Generally, no surge protection devices
need to be installed; therefore, the antenna cables are directly connected to the AP's antenna ports.
2. If higher surge protection capability is required, the customer can purchase a surge protection device. When installing the
surge protection device, ensure that it is connected to a ground cable.
a
Waterproof adhesive tape
Ground cable
NOTE
Surge
protection
device
c
b
Waterproof
adhesive
tape
Feed line
Feed line
● Wrap the feed line using one-layer PVC black insulation tape, three-layer waterproof adhesive tape, and then three-layer
PVC black insulation tape.
● Stretch the waterproof adhesive tape evenly and ensure that the upper layer of the tap overlaps 1/2 of the lower layer.
Each layer should be attached tightly.
● Wrap the three-layer waterproof adhesive tape from bottom to up, from up to bottom, and from bottom to up in order.
●
Connecting optical fibers
1. The right figure shows the appearance of the optical fiber
：
The thread must be secured properly; otherwise, optical fibers may be damaged. When removing optical fibers, remove the
waterproof PG connector, and then remove the optical fiber
connected to the AP. When removing the waterproof PG
connector, use the ejector lever to clutch the optical fiber tube. This prevents the optical fiber tube from rotating with the
waterproof PG connector and protects optical fibers.
7
NOTE
Install an optical module as shown in step a
before connecting the fiber.
a
b
c
d
e
f
