to the correct position. Rotate the external connector shell clockwise until the red ring is
not visible
l
Connect the optical fiber correctly; otherwise, the optical fiber may be damaged.
l
Bundle the optical fibers with binding tapes every 1 m.
Connecting network cables
1.
Use a shielded straight-through cable (CAT5E or higher) with a diameter of 6 mm. Cut
the cable into a proper length based on the distance between the AP and the PSE device,
strip the cables on both ends, and crimp the wires into RJ45 connectors.
2.
Make a network cable onsite according to pin assignment in
communication quality is affected even if devices can be connected.
Table 2-5
Pin assignment
X1 Pin
Wire Color
X2 Pin
1
White and orange
1
2
Orange
2
3
White and green
3
4
Blue
4
5
White and blue
5
6
Green
6
7
White and brown
7
8
Brown
8
NOTE
Actually, APs use shielded straight-through network cables, which are connected in the same way
as unshielded network cables.
3.
Put the network cable through waterproof PG connectors. Connect the RJ45 connector to
the Ethernet interface on the AP and secure the waterproof PG connector. See figures b,
c, and d.
AP8082DN and AP8182DN
Hardware Installation and Maintenance Guide
2 AP Installation
Issue 03 (2019-04-01)
Copyright © Huawei Technologies Co., Ltd.
34
