Installation
Circuit schematic diagram
Operation
1. Remove the fixing screw of the mounting plate, and then remove the mounting plate, as shown
in Figure 1.
2. When installing on the soft wall such as wood board, use ST5 self-tapping nail to fix the
installation board on the wall, as shown in Figure 2.
3. After the installation plate is fixed, hang the air curtain machine on the installation plate, and
then tighten the installation plate and the fixing screw of the air curtain body to ensure firm
installation, as shown in Figure 3.
1. Press the “ON/OFF” button to start the air curtain machine
(at this time, the air curtain works at high speed by default).
2. Press the “Fan speed” button to switch between high speed
and low speed.
3. Press the “UV” button to turn ON/OFF the UV light, and the
UV light will automatically turn off after being turned on for
60 minutes by default. To turn on the UV again, press the “UV”
button again.
Note: Do not look directly at the open UV lamp to avoid
radiation damage; Do not turn on the ULTRAVIOLET lamp
when opening the cover plate.
Figure 1
Figure 2
Figure 3
1
2
3
Mounting
plate
ST5 self-tapping nail
ELECTRONIC
BALLAST
UV LAMP
THERMAL
CUT-OUT
THERMAL
CUT-OUT
RECEIVE
IC
RECEIVE
I/O
UV
Ultraviolet (UV)
Fan speed
ON/OFF
Be careful of
UV radiation!
8
