7
1.Cutting mode selection
2. Cutting parameters
(which contains air pressure/output voltage/ the recommended
length of the cutting torch) Hold down the function button for 1 second, the cutting
parameters flashes, then you can adjust the air pressure. Press on the function button
briefly to set Bar, Mpa or Psi. Continue to press on function button briefly, the output
voltage and the recommended length of the cutting torch will display as shown in the
Figure 6 and 7. Figure 6 shows the arc voltage and that the arc is on. Figure 7 shows
the torch length in meters, arc is not on.
Figure 3. Figure 4.
Figure 5.
Figure 6.
Figure 7.
Grid cutting mode: use the encoder to adjust the cutting
current, press on the function button briefly to switch cutting
mode.
The current range is 20-45A, the air pressure range is 4.2-
5.6Bar.
Normal cutting mode, use the encoder to adjust the cutting
current, press on function button briefly to switch cutting
mode.
The current range is 20-45A, the air pressure range is 4.2-
5.6Bar.
Gouging/marking cutting mode, use the encoder to adjust the
cutting current, press on function button briefly to switch
operational mode. The current range is 10-45A. When the
current is between 20A and 45A, the cutting mode is
gouging, the air pressure range is 2.1-3.5 Bar. When the
current is between 10A and 20A, the cutting mode is
marking, the air pressure range is 2.1-3.1Bar.
Summary of Contents for MicroCut 45 DV
Page 2: ...I...
Page 19: ...14 6 Cutting Guidelines...
