HTI 1437137, Instruction Manual

Page: 3 / 6

P. 3
P. 4
Tools Required
Screwdriver
(not included)
Pliers
(not included)
Hammer
(not included)
Spanner
(not included)
1
4
2
5
3
6
Quad Body *1 Handlebar*1 Bumper*1
M10 Washer*1 M8 Nut*1 M3.5x12*3
7
10
8
11
9
12
Gear Box *1 Driving Wheel*1 Wheels*3
Wheel hub*4 Rear Axle*1 M10 Washer*8
13
Split Pin*4
PARTS DIAGRAM
M10 Washer
M8 Nut
M8 Nut
Washer
ASSEMBLY STEPS
3. Install the Handlebar
4. Install the Bumper 5. Connect to Battery
1. Install Rear wheels 2. Install the front wheels
A
B
• Ensure the lower part of handlebar locates correctly into the front axle.
• Then push down the Handlebar, and fasten with washer and M8 Nut
(Pic A & B with axle.)
• Unfasten the M8 Nut from Handlebar, connect the
wire connections between the steering wheel and
Quad body.
• Install the Handlebar and steering column, put through
the hole on the top of the ride on body.
• This product requires adult assembly. Please set aside at least 40 minutes for assembly.
• Children can be harmed by small parts, sharp edges and sharp points in the vehicle's unassembled state.
Care should be taken in unpacking and assembly of the Quad. Children should not handle parts, or help in assembly of the vehicle.
• Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded.
• Assembly tools needed: screwdriver(not included), pliers(not included), hammer(not included), spanner(not included).
• Fix the washer, wheel, washer and split pin onto the axle
in proper order.
• Fix the wheel hub.
• Fix another wheel on the other side.
• Place Quad body upside down for easy assembly.
• Put a washer into the rear axle then push the rear axle from the right to the left
• Put a washer, wheel, washer onto the axle in proper order and fix with split pin
• Fix the wheel hub to complete
• Connect the gear box wire at the other side
• Put the gear box, driving wheel, washer in proper order and fix with split pin
• Install the Bumper to the corresponding position as shown,
and fasten with screws.
• Unscrew the seat fastener, and open the seat compartment.
Connect the battery with wire as shown. Replace the seat cover
and fasten with the screw.
Handlebar
M3.5x12 Screw
Bumper
Seat Screw
Power
connector
Wire
connector
Gear box
Driving wheel Rear axle
Wheel Splirt pin
Splirt pin
M10 Washer
M10 Washer
Rim
Wheel hub
Wheel hub
Split pin
Wheel
Front axle
M10 Washer
Wheel hub
9
10
12
13
10
10
13
12
13
8
12
9
7
12
6
4
5
12
12
2
1
11
3
9
13
12
10