HT210
EN - 9
5.3. RESISTANCE AND CONTINUITY TEST MEASUREMENTS
CAUTION
Before taking resistance measurements in circuit remove power from the
circuit being tested and discharge all capacitors.
Fig. 4: Using the instrument for Resistance and Continuity test measurements
1. Switch on
. “
” symbol is displayed
2. Insert the test leads into the jacks, the red plug into
V
Hz%
jack and black
plug into
COM
jack
3. Connect the test leads to the circuit under test (see Fig. 4). The resistance value is
displayed
4. If the message "
O
.
L
" is displayed the higher range is reached
5. Pressing the
MODE
key until the symbol is shown at display to meaning the
Continuity test and connect the meter as resistance measurement. Buzzer emits sound
if the measured resistance value is less about R<35
6. For HOLD function please refer to § 4.2