Important
Always refer to the vehicle’s Workshop Manual when
removing vehicle components.
Page 03 of
Step 2
Step 3
Step 1
P
P
Nissan pointers
P
P
• Disconnect the vehicle battery
(1)
.
• Disconnect the ring terminals and fuse holder from the battery
power harness at the 2-way connector.
• Route the battery power harness, starting from the front of the
tub, along the chassis rail, up to the engine bay to the vehicle
battery.
Note: Do not connect to the battery yet.
• Connect the Battery Power Harness 2-way connector to the
mating connector on the wires pre-run in the ute lid.
• Remove the end caps
(1)
covering the screw holes on the LED
Lamp
(2)
and retain them for fitting at the end of the installation.
• Install the Push Button Switch
(3)
and LED Lamp
(2)
on to the cover
(4)
as shown.
4
3
2
1
• Remove the plastic cover
(1)
from the hard lid locking
mechanism by removing the 4 screws
(2)
(retain the screws for
later use).
2
2
1
1
1
2
2
2
FI Doc No: FI11793 - Issue: 2 - 12/04/17
HSP UTE LIDS
05
© Lumen Australia 2017