HSM Primo 1401, Operating Instructions Manual

Page: 13 / 76

08/2011
Primo 1401
13
english
9 Technical data
Cutting type Strip cut Cross cut
Shred size ( mm) 5.8 3.9 1.9 3.9 x 30 1.9 x 15
Sa fe ty ra ting German DIN 32757 – 1
2 2 3 3 4
Cutting ca pa ci ty* (Sheet) DIN A4 70 g/m
2
80 g/m
2
22 - 24
17 - 19 16 - 18
13 - 15 12 - 14
9 - 11
12 - 14
9 - 11
9 - 11
7 - 9
Weight
11,5 kg
12,5 kg
Cutting speed 80 mm/s 90 mm/s
Lo ading width 240 mm
Voltage
230 V, 50 Hz
100 V, 50/60 Hz – 115 V, 60 Hz
Power for the maximum number of sheets 440 W
Operating mode Continuous operation
Dimensions W x D x H (mm) 375 x 281 x 583
Ambient conditions in operation:
Temperature
Relative humidity
Height above sea-level (MSL) -10 °C to +25 °C
max. 90 %, without condensation
max. 2,000 m
Volume of shred. mat. container 33 l
Noise level (Idle running/ load) 58 dB(A) / 59 - 63 dB(A)
EC Declaration of Conformity
The manufacturer HSM GmbH + Co. KG , Austraße 1 - 9, D-88699 Frickingen hereby declares that the machine,
referred to here as
document shredder
Primo 1401
corresponds to the health and safety requirements of the following EC directives listed below due to its conception and
design of the version in which it was put into circulation by us:
Low voltage directive 2006 / 95 / EEC
EMC directive 2004 / 108 / EC
Applied standards and technical speci
fi cations:
• EN 55014-1:2006 • EN 55014-2:1997 +A1:2001
• EN 61000-3-2:2006 • EN 61000-4-5:2006
• EN 61000-3-3:1995 + A1:2001 + A2:2005 • EN 60950-1:2006 +A1:2010
Frickingen, 01.03.2011
Rolf
Gasteier - Technical Director
* The maximum number of sheets (DIN A4, 70 g/m² or 80 g/m²), fed lengthways, which can be cut in one cycle. The
performance data is determined when the motor is cold and the cutting device is freshly oiled. A weaker mains voltage
or a different mains frequency to the one speci
fi ed could result in less sheet capacity and increased noise during op-
eration. The sheet capacity can vary depending on the structure and properties of the paper and on the way it enters.
The performance data in 80 g/m² is calculated.