Shredder
HSM FA 400.2
2004-12
13
Greasing the drive chains and cogs (twice yearly)
• Switch off the shredder.
• Pull out the power plug.
• Remove the tray and the cover panels.
• Grease the cogs and the drive chains from the motor to the cutting apparatus, the cutting block
to the feed belt and the cutting block to the regulating roller.
Recommended lubricating grease: K2K in accordance with DIN 51502/DIN 51825
• Put the side cover panels and the tray back on.
Tightening the feed belt
The feed belt should not slip when loaded with material.
• Switch off the shredder.
• Loosen the hex nuts (1) on the left and right sides of the snub roller.
• Loosen the lock nuts (2) of the tensioning bolts (3).
• Tighten the feed belt evenly using the tensioning bolts.
Note:
Only tighten the feed belt until it stops slipping. The feed belt bearing may be damaged if it is
tightened too much.
• Tighten the hex nuts on the snub roller and the lock nuts on the tensioning bolts again.
You must check that the feed belt runs straight:
Switch on the shredder and let it run for 10 minutes.
During this time, the feed belt must run in the middle of the snub roller. If it slips to the left or right
edge, you must alter the setting of the snub roller.
Checking the feed belt for wear
The surface of the feed belt can become worn after long periods of use. If you can see the fabric inlay in the
belt, it must be replaced.
Please notify our customer service.
0
I
0
1
1
2
3
2
3
0
I
0
Summary of Contents for HSM FA 400.2
