HSM HSM FA 400.2, Operating Manual

Page: 10 / 23

HSM FA 400.2 Shredder
10 2004-12
Place the material to be shredded on the loading
tray and then place batches on the feed belt.
If material that is not supposed to be shredded is mistakenly placed onto the belt, never attempt to
pull it out
• Press the stop button.
➪
The drive stops.
• Press the reverse button.
➪
The cutting block and feed belt run in reverse.
• You can now remove the material from the belt and start the shredder again by pressing the start
button.
Waste bag full
➪
The red LED on the keypad lights up.
➪
The shredder switches off automatically.
• Press the reverse button for approx. 3 seconds.
➪
Part of the material is pulled back into the apparatus.
• Open the front door and shake the waste trolley
➪
The cut material spreads in the cut material sack and does not fall into the interior of the
shredder.
• Pull the waste trolley out and change the cut material sack.
• Push the trolley back in and start the shredder again by pressing the green start button.
Stopping the shredder
• Press the stop button.
➪
The cutting block and feed belt stop.
➪
The shredder switches to standby mode.
Switching off the shredder
• Turn the main switch on the paper shredder or the baling press to 0.
You can secure the main switch in this position using a padlock.
Shredding material
0
I
0