HSM Classic 90.2, Operating Instructions Manual

Page: 13 / 76

09/2011 Classic 90.2 • Primo 900
13
english
9 Technical data
EC Declaration of Conformity
The manufacturer HSM GmbH + Co. KG , Austraße 1 - 9, D-88699 Frickingen hereby declares that the machine,
referred to here as
document shredder
HSM Classic 90.2 / Primo 900
corresponds to the health and safety requirements of the following EC directives listed below due to its conception and
design of the version in which it was put into circulation by us:
Low voltage directive 2006 / 95 / EEC
EMC directive 2004 / 108 / EC
Applied standards and technical speci fi cations:
• EN 13857:2008 • EN 55014-1:2006
• EN 55014-2:1997 + A1:2001 • EN 61000-3-2:2006
• EN 61000-3-3:2008 • EN 60950-1:2006 +A11:2009
Frickingen, 01.03.2010
Rolf
Gasteier - Technical Director
* The maximum number of sheets (DIN A4, 70 g/m² or 80 g/m²), fed lengthways, which can be cut in one cycle. The
performance data is determined when the motor is cold and the cutting device is freshly oiled. A weaker mains voltage
or a different mains frequency to the one speci
fi ed could result in less sheet capacity and increased noise during op-
eration. The sheet capacity can vary depending on the structure and properties of the paper and on the way it enters.
The performance data in 80 g/m² is calculated.
Cutting type Strip cut Cross cut
Shred size ( mm) 3.9 5.8 4 x 25
Sa fe ty ra ting German DIN 32757 – 1 2 2 3
Cutting ca pa ci ty* (Sheet) DIN A4 70 g/m
2
80 g/m
2
12
7 - 9
15
10 - 12
6
3 - 4
Weight
4,0 kg
4,5 kg
Lo ading width 225 mm
Cutting speed 60 mm/s
Voltage 230 V, 50 Hz
Power for the maximum number of sheets 150 W
Operating mode Brief operation
Operating time 2 min
Idle time 15 min
Ambient conditions in operation:
Temperature
Relative humidity
Height above sea-level (MSL) -10 °C to +40 °C
max. 90 %, without condensation
max. 2,000 m
Dimensions W x D x H (mm) 326 x 240 x 423
Volume of shred. mat. container 25 l
Noise level (idle running) 60 dB (A)