HSGM
Heißschneide-Geräte
u.- Maschinen GmbH
HSGM GmbH
Phone : +49 (0) 6123 9978-0
B-00-VW-GB.DOC
In der Rehbach 13
Fax : +49 (0) 6123 9978-40
Status: 16.05.2018
D-65396 Walluf
Email: [email protected]
Printed: 16.05.2018
http://www.hsgm.com
Page: 4
Caution!
To guarantee perfect electrical continuity, it is important to ensure the blade band is screwed tight when
inserted. Poor connections or loose screw connections result in unnecessary heating of terminals, the
blade band output is reduced, and the heating of one or both terminals may damage the clamp pieces.
After activating the on/off switch, the machine is ready for use.
This means:
The signalling lamp on the on/off switch is lit up.
The blade band should not heat up.
Determining the temperature setting on the dial:
A specific temperature is needed in line with the material, thickness and cutting speed.
This setting is made using the temperature dial.
The effective settings for the power control dial (= temperature dial) should be determined empirically, because the
power needed by the blade band depends greatly on the type and thickness of the material to be cut, and is
therefore subject to strong fluctuations.
Setting
-
Switch the machine on as described above.
-
Turn the temperature dial
slowly
in a clockwise direction until the blade band inserted is
dark red
.
Operation
Never operate your heat cutting machine when it has just been moved from a cold room into a warm room.
The
condensation that occurs may under unfavourable circumstances damage your heat cutting machine.
Leave your heating cutting machine turned off and allow it to reach room temperature.
Maintenance
Regularly inspect the technical safety of your heat cutting machine, e.g. for damage to the power cord or the housing.
If it is to be assumed that safe operation is no longer possible, the machine must be taken out of use and secured to prevent
inadvertent use. Pull the plug out of the socket!
It may be assumed that safe operation is no longer possible in the following circumstances:
If the machine shows signs of damage;
If the machine no longer works;
After prolonged storage in unfavourable conditions; or
After rough handling during transport.
To clean the machine, it is sufficient to wipe any dust or other dirt off using a dry cloth and/or a soft brush.
Repairs may only be conducted by the manufacturer or its customer service.
Warning!
The machine must be disconnected from the power supply during maintenance and when replacing
parts. This is done by pulling out the plug.
The operator must be able to check that the plug is still disconnected from each point of access.
