Installation and adjustment
20
2021-06-23
FM 239 MuW Beta Type Z Rev.01
distributed by
Procedure
1.
Place the motor and the clutch components in mounting position
adjacent to the linear unit.
2.
Check the direction of rotation of the motor. It must take into
account the safety limit switches (figure 6). Alter the direction of the
motor as necessary.
3.
If the clutch diameter is less than the measure D on the motor
housing (4), first mount clutch half 1 (1) (hole flush with drive shaft)
and then the motor housing (4)
(figure 7).
If the clutch diameter is greater than the measure D on the motor
housing (4), first mount the motor housing (4) and then the clutch
half 1 (1) (hole flush with drive shaft). Tighten the clutch clamping
screw through the mounting hole on the motor housing (4).
4.
Slot the clutch ring (2) onto the clutch.
5.
Mount clutch half 2 (3) on the motor pin.
6.
Mount the motor on the motor housing.
Tightening torque [Nm] of clamping screws
Screw
SW
Torque
M6
5
14
M8
6
35
M10
8
65
M12
10
74
Summary of Contents for Beta 40-ZGS
Page 2: ......